Please read the posts in the Announcements section about the current status of Cumulus development now that I have retired

Please read this post before posting

Latest Cumulus release v1.9.4 (build 1099) - Nov 28 2014
Latest Cumulus MX release - v3.0.0 build 3043 Jan 20 2017. See this post for download

Modular station idea

For discussion of DIY weather equipment - sensors, accessories, improvements to existing kit etc
StuW
Posts: 1
Joined: Tue Feb 02, 2016 12:55 pm
Weather Station: Watson W-8681 (Maplin)
Operating System: Ubuntu Server / Windows 7
Location: Leyland, Lancashire

Modular station idea

Postby StuW » Fri Dec 02, 2016 3:44 pm

Hi all

My Maplin cheapy station has finally given up after 5 years with the dreaded constant red led so i was thinking of using the parts to make my own system.

My idea is to use ESP8266 wifi boards which has a programmable MCU for each area of the station. Each board would be responsible for a separate area of information e.g. Wind (anemometer and direction vane), air (temp and humidity) etc... and each would have a built in VERY basic webserver for retrieval of values. With rechargeable batteries and a small solar panel per unit it should be completely self contained for years at a time.

Server side I plan on using a Raspberrry Pi to enable long term logging and more flexibility.

Is my idea feasible?

water01
Posts: 1403
Joined: Sat Aug 13, 2011 9:33 am
Weather Station: WH1081
Operating System: Windows 7 64bit HP SP1
Location: Somewhere in the USA
Contact:

Re: Modular station idea

Postby water01 » Sat Dec 03, 2016 11:26 pm

Not sure I would bother when this is available viewtopic.php?f=16&t=12083 as this does it all and allows use of the Fine Offset modules.

AllyCat
Posts: 1004
Joined: Sat Feb 26, 2011 1:58 pm
Weather Station: Fine Offset 1080/1 & 3080
Operating System: Windows XP SP3
Location: SE London

Re: Modular station idea

Postby AllyCat » Mon Dec 05, 2016 10:30 am

Hi,

Indeed, why reinvent the wheel?

However, my main "concern" with the Weatherduino transmitters is their rather high (solar) Power Budget, for the higher latitudes such as the UK. Around a 50 watt (rated) panel (that's several square feet) and a SLA battery have been suggested in this thread. I suspect there might be similar (or worse) issues using the ESP8266.

Personally, I'm looking more at a dedicated low power microcontroller (PIC) and one of the modern 3.3 volt highly-integrated UHF (434/868 MHz) transceiver modules such as the HC-12. Currently (in December) my "test bed" battery (a single AA cell) is still "topping out" almost every day, from a 250 mW PV panel (~15 sq cms). ;)

But I still have decide whether to port the (Arduino) "virtualwire" protocol onto the new processor, or adapt the receiever protocol as for the "AuriolDiuino" version.

Cheers, Alan.


Return to “Homebuilt”

Who is online

Users browsing this forum: No registered users and 3 guests