Sandaysoft

The new webtag is returning a 0 value.

-Tom

_________________
Tom Keramidas, Lake Zurich, IL, USA

I added this to my webpage yesterday and it come up as 0.0. However today it reads correct. As Steve replied here: viewtopic.php?f=20&t=7926 the figure for the tag would have to be written to yesterday.ini.

Therefore wait for the daily rollover for it to work.

_________________
Regards, Matt of Brisbane, Australia
Web Site: http://www.localweatherdata.0glo.com

Same here! Thanks.

_________________
Tom Keramidas, Lake Zurich, IL, USA

Steve,

I had the same after implementing <#avgtempY> untill today's rollover.
However, looking at the actual temp measurements, how is the average calculated?
High = 29 / Low = 21 -> Average is 24.9 (according to me it should show 25....?
Besides this, you keep teasing me with the Humidex values......
In the Yesterday.ini file, again it shows "Humidex" (see attachment) but shown value is incorrect (would have been nice to see the Yesterday high Humidex, since I broke a local record with 44.6 C

Cheers,

Arthur

_________________
http://www.altonaweather.ca

As far as I know the averagetemperature by Cumulus is calculated by minutes and not maximim+minimum divided by 2.

_________________
Ron



Apeldoorn, The Netherlands

Its also my understanding that the average is by each minute rather than the min/max average, this is is mentioned here in the Wiki: http://wiki.sandaysoft.com/a/Average_temperature

_________________
Regards, Matt of Brisbane, Australia
Web Site: http://www.localweatherdata.0glo.com

As I've said before, Cumulus didn't write that [Humidex] section header, it writes a [HeatIndex] section header. I think you must have edited the files and changed [HeatIndex] to [Humidex], I can't think of any other way it could have got there. Presumably you have a [HeatIndex] section at the end of the file? Cumulus would have re-created it when the original one was renamed. That bogus [Humidex] section won't be being updated.

_________________
Steve
Sanday Weather
----------------------------------------------------------------------------------------------------------------------------------
Like Cumulus and want to support it? Please donate!

Thanks guys.
Checked WiKi and Ave-Temp is now clear to me

Steve,
Indeed, I changed from Heatindex to Humidex display and and the bottom of Yesterday.ini there is the Heatindex correctly displayed, so Humidex display must have gotten there "on its own"....!!!!

Arthur

_________________
http://www.altonaweather.ca