Page 2 of 2

Re: PressOffset

Posted: Wed Nov 15, 2017 4:34 pm
by steve
Yes, I can see that from the files you uploaded. Perhaps the USB interface on your console has locked up - a common problem with Fine Offset stations. Presumably you are you using the ‘synchronise’ setting but this hasn’t helped? All I can suggest is the same as always, that you reset your console.

Re: PressOffset

Posted: Thu Nov 16, 2017 9:22 pm
by malmeida
After restarting Cumulus again it connected to the station and the pressure value is correct.

Re: PressOffset

Posted: Fri Nov 17, 2017 4:37 pm
by malmeida
I restarted Cumulus again and it connected to the station. Now the pressure values are correct.

Re: PressOffset

Posted: Thu Dec 07, 2017 3:25 pm
by malmeida
Now the temperature trend graph is empty. If I delete tempdata.json on the site and update it from Cumulus to the site I can see the respective temperature graph but only for a while. The other trend graphs are from December 2. The file ftplog.txt has 307MB, the only date that it has is 2016-11-01 and it hasn't tempdata.json. I know that Cumulus has some difficulty to upload the files but it must have some other thing wrong.

Re: PressOffset

Posted: Thu Dec 07, 2017 4:20 pm
by steve
The tempdata.json file that you delete, is it zero length?

Delete the ftplog.txt file and then turn on ftp logging.

Re: PressOffset

Posted: Fri Dec 08, 2017 1:47 pm
by malmeida
The file temdata.json was not emty. I deleted the file ftplog.txt in Cumulusmx because I didn't find it in the site. As I didn't find a way to logging ftp in dashboard and I have logging=1 in [ftp site] of Cumulus.ini, I rebooted Cumulus.

Re: PressOffset

Posted: Fri Dec 08, 2017 4:17 pm
by malmeida
Now I can see the temperature trend graph updated!

Re: PressOffset

Posted: Fri Dec 08, 2017 4:50 pm
by steve
You were probably having ftp issues resulting in a truncated file.