Temp/humidity sensor 4 core/6 core cable
Posted: Sun 25 Feb 2018 6:01 pm
Hi All,
I have recently upgraded from a Wizard 3 to a Vanatge Pro and tried to use existing sensors where possible. Due to sensor locations and location of ISS (indoors) I was informed that I could use the exsiting 4 core weather wizard 3 cable to connect the temp/humidity sensor of the "new" vanatage Pro as the outside conductors in the RJ11 are not used (white & blue) The RJ11 plug of the VP temp/hum sensor has 6 conductors, hence my concern as the original cable is only 4 core. Now that it is installed the Humidity sensor constantly displays 100%, temp display working OK.
The sensor worked perfectly OK when plugged into the ISS with only the original cable length.
Have I been unfortanate in this install OR, I do actually need to purchase a 6 core cable run? Cable run is about 13 mtrs.
Thanks
Steve
I have recently upgraded from a Wizard 3 to a Vanatge Pro and tried to use existing sensors where possible. Due to sensor locations and location of ISS (indoors) I was informed that I could use the exsiting 4 core weather wizard 3 cable to connect the temp/humidity sensor of the "new" vanatage Pro as the outside conductors in the RJ11 are not used (white & blue) The RJ11 plug of the VP temp/hum sensor has 6 conductors, hence my concern as the original cable is only 4 core. Now that it is installed the Humidity sensor constantly displays 100%, temp display working OK.
The sensor worked perfectly OK when plugged into the ISS with only the original cable length.
Have I been unfortanate in this install OR, I do actually need to purchase a 6 core cable run? Cable run is about 13 mtrs.
Thanks
Steve