Hi,
Is there any way to change the Y axis position for the wind bearing in select-a-chart? In my area the wind is predominantly Northerly, moving between slightly NNW and NNE. This means the chart shows points jumping between the top and bottom of the Y axis. Am I able to offset the Y axis so West is at the top? This would mean my predominant winds would show much clearer.
Thanks,
Tom
Welcome to the Cumulus Support forum.
Latest Cumulus MX V4 release 4.0.1 (build 4023) - 16 May 2024
Latest Cumulus MX V3 release 3.28.6 (build 3283) - 21 March 2024
Legacy Cumulus 1 release 1.9.4 (build 1099) - 28 November 2014
(a patch is available for 1.9.4 build 1099 that extends the date range of drop-down menus to 2030)
Download the Software (Cumulus MX / Cumulus 1 and other related items) from the Wiki
Latest Cumulus MX V4 release 4.0.1 (build 4023) - 16 May 2024
Latest Cumulus MX V3 release 3.28.6 (build 3283) - 21 March 2024
Legacy Cumulus 1 release 1.9.4 (build 1099) - 28 November 2014
(a patch is available for 1.9.4 build 1099 that extends the date range of drop-down menus to 2030)
Download the Software (Cumulus MX / Cumulus 1 and other related items) from the Wiki
Change wind bearing select-a-chart north position
Moderator: mcrossley
- mcrossley
- Posts: 12903
- Joined: Thu 07 Jan 2010 9:44 pm
- Weather Station: Davis VP2/WLL
- Operating System: Bullseye Lite rPi
- Location: Wilmslow, Cheshire, UK
- Contact:
Re: Change wind bearing select-a-chart north position
Not easily because the direction changes from 1 degree to 360 degrees, so there will always be a disconnect on a linear graph.